Editing commands for whole slabs

With this command you can edit the corner points and edges of the entire slab. In the case of layered slabs, editing will affect each layer.

You can access editing commands from the Shortcut menu:

Move node

Click on any corner point of the slab to change its position.

Parallel shifting (offset)

With this command you can offset one side of the slab or enlarge or reduce the entire contour of the slab.

Specify the new position for the slab side. You can also specify the offset by entering its value; to do so, move the mouse pointer in the desired direction and enter the value;

Select the ALL option of the prompt to move each side of the slab contour together.

EnterCompletes the command.

Inserting nodes

Click on any side of the slab to insert a new node.

Option:

SPOLYGON

If you select the SPOLYGON keyword, this will activate the Add polyline command

Adding polylines

Click on any side of the slab to add multiple nodes by a polyline to the slab.

Deleting nodes

This command deletes any selected corner point of the slab.

Converting lines to arcs

This command performs the following conversions:

The command converts linear slab sides to arced ones; you can also modify the radius of the arch in the case of an arced slab.

Specify a point. The arced slab will intersect this point. Select one of the following options:

OPTIONS:

DIAMETER	Enter diameter value.
RADIUS	Enter radius value.
PERIMETER	Enter perimeter value (arc length).
ARC	Enter chord value for the arc.

Converting arcs to lines

Use this command to convert arced slab sides to linear ones.